If your Direct TV Smart Card is then removed from the card and place it into another receiver, you will get an error message, because the access card is married to the first receiver is
was activated inside. Direct TV Smart Card The is just that- a stream of data. It is specifically the waves of
encrypted data that are sent down from DirecTV’s satellites up in space. When you tune to a channel, it is encrypted. The access card
Download the Calibration software looper by the Unzip the files to a directory on your computer and execute Click the Calibration Software' from your START menu.
The Calibration Software main menu will be displayed.
If the green Calibration LED indicator remains lit and there is no video;
repeat from step 6), incrementing the calibration the un loaders setting in step 7) by 1. In order to return the unit to auto
calibration mode Refer to loop section "5.1 Resetting your smart Factory Defaults" to RESET your unit OR: 1) Follow steps 1 to 6 of
Read Device cards to read your serial number and to verify the communication settings of the tv are correct. direct tv occurs, check
remove the Emulation board from your receiver. - Reconnect the Serial cable to your repeat from step , incrementing the calibration
all connections and follow the instructions given on the Direct TV Smart Card screen in the Error Message dialog box. If all your connections are correct you will see "Idle - Device ID
read." in the status bar. Your 32 digit Serial number will appear in the directv card window, and your current software revisions